LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (2.5L 4-CYL - VIN [K]) >> Removal & Installation >> Water Pump >> Removal

Water Pump: Removal

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Dodge Dakota, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain cooling system. Remove upper and lower radiator hoses. On A/C-equipped models, remove A/C compressor with lines attached from solid mount bracket and set aside. Remove alternator.
  2. Remove mounting bolts No. 1, 4, 5, 6 and 7 from solid mount A/C compressor bracket. See Figure. Remove front nut No. 2, and remove (or loosen) front bolt No. 3. Rotate solid mount A/C compressor bracket away from engine, and slide on stud (No. 2) until free.
  3. On models without A/C, remove alternator and mounting bracket. On all models, disconnect hoses from water pump. Remove water pump housing-to-cylinder block bolts. Remove water pump housing, water pump and "O" ring.
  4. Remove water pump pulley. Remove water pump-to-housing bolts. Separate water pump from housing. Remove "O" ring from housing groove.
scientia non olet · About LEMON Manuals