Camshaft, Crankshaft Or Intermediate Shaft Sprocket Oil Seal: Removal

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Dodge Dakota, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.

Remove timing belt. See TIMING BELT under REMOVAL & INSTALLATION. For crankshaft sprocket seal replacement, remove crankshaft sprocket bolt. Using Crankshaft Sprocket Puller/Installer (C-4685) and puller insert, remove crankshaft sprocket. See Fig 1.
To remove camshaft or intermediate shaft sprockets, use Sprocket Holder (C-4687) and Adapter (C-4687-1) to hold sprocket and remove sprocket bolt. See Figure. Note direction of sprocket offset for installation reference. Remove sprocket.
Using Crankshaft Sprocket Seal Remover (C-6341) or Intermediate Shaft/Camshaft Seal Remover (C-4679), remove sprocket oil seals. See Fig 2.

Fig 1: Removing & Installing Crankshaft Sprocket

Courtesy of CHRYSLER CORP.

Fig 2: Removing Sprocket Oil Seals

Courtesy of CHRYSLER CORP.