Test 7C - Short To Battery
WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION in appropriate TESTS W/CODES
article below. For appropriate wiring diagram, see WIRING DIAGRAMS
section. Perform TEST VER-1 after each repair.
- TESTS W/CODES - 3.9L
- TESTS W/CODES - 5.2L GASOLINE
- TESTS W/CODES - 5.9L GASOLINECAUTION: Always turn ignition switch to OFF position before disconnecting or connecting any module connector.
- Using scan tool in voltmeter mode, check voltage at Controller Anti-Lock Brake (CAB) module connector terminal No. 41, pedal travel sensor return circuit (Red/Black wire).
- If voltage is more than 10 volts, repair short to voltage in Red/Black wire and replace CAB module. Perform TEST VER-1. If voltage is less than 10 volts, replace CAB module. Perform TEST VER-1.
NOTE:
Test procedures skip from TEST 7C to TEST 7E. No test procedures have been omitted.