Test Ch-VER - Charging Verification

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Ensure all engine components are connected. Reassemble and reconnect components as necessary.

If PCM has been replaced and vehicle is equipped with a factory theft alarm, start vehicle at least 20 times so alarm can be activated when desired. Connect DRB to PCM data link connector, and erase faults.
Start engine. Raise engine speed to 2000 RPM for at least 30 seconds. Allow engine to idle. Turn engine off. Turn ignition on. Using DRB, check for fault messages. If any fault is present, repair is incomplete. Check all pertinent Technical Service Bulletins (TSBs) and return to TEST TC-1A, if necessary. If there are no other faults, repair is complete.