Removal & Installation (2.5L)
WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. On models with A/C, remove A/C drive belt. Remove bolts retaining A/C compressor to mounting bracket. Without disconnecting A/C refrigerant lines, move A/C compressor aside to allow generator removal.
- Remove generator drive belt and generator mounting bolts. Move generator aside to access wire connectors. On Bosch generator, remove B+ terminal nut, field terminal nuts and ground harness hold down nuts. Remove wire connector assembly.
- On Nippondenso generator, remove field terminal nuts, ground terminal nut, wire harness nut and B+ terminal nut. Remove B+ terminal nut last to prevent damage to insulator.
- Remove generator from vehicle. To install, reverse removal procedure. Tighten to specification. See TORQUE SPECIFICATIONS table.