Test 94A - Seat Belt Lamp On Constantly

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always turn ignition off prior to disconnecting any module connector.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS section at the end of this article. Perform TEST VER-1B after each repair.

Turn ignition off. Disconnect Body Control Module (BCM) Blue connector. BCM is located behind left side knee panel. Check and repair connections as necessary. If connections are okay, go to next step.
Turn ignition on. If seat belt warning lamp is off, replace BCM. If seat belt warning lamp is on, repair short to ground in Dark Blue/Red wire.