Test 91B - Poor Sound Quality From All Speakers
WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
section at the end of this article. Perform TEST VER-1B after each repair.
NOTE:
Radio must remain on during this test.
- Remove speaker power relay (first relay from left, bottom row) from micro relay center, located behind center console. Go to next step.
- Ensure scan tool is still backprobing radio Black connector terminal No. 1 (Dark Green/Red wire). If voltage is more than 10 volts, replace speaker power relay. If voltage is less than 10 volts, go to next step.
- Disconnect radio Black connector. With scan tool still connected, switch scan tool to ohmmeter mode. If resistance is less than 5 ohms, repair short to ground in Dark Green/Red wire. If resistance is more than 5 ohms, replace radio.