Test 75A - Doors Fail To Unlock From One Switch

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS section at the end of this article. Perform TEST VER-1B after each repair.

CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.

Turn ignition off. Gain access to inoperative door lock switch. Remove door unlock relay (third relay from right, bottom row) from micro relay center, located behind center console. Go to next step.
Using an external ohmmeter, check resistance of Pink/Violet wire between door unlock relay connector and door lock switch. If resistance is more than 5 ohms, repair open Pink/Violet wire. If resistance is less than 5 ohms, replace door lock switch.