LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Controls - Tests W/Codes - Body Control Computer) >> Self-Diagnostic Tests >> Test 52A - Inoperative Warning Lamp

Test 52A - Inoperative Warning Lamp

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  section at the end of this article. Perform TEST VER-1B after each repair.
CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.
  1. Turn ignition off. Disconnect MIC connector. Check connector, and clean or repair connector as necessary. If connector is okay, go to next step.
  2. Remove and inspect inoperative warning lamp. If lamp is open, replace lamp. If lamp is okay, replace MIC printed circuit board.