Test 47A - Faulty Individual Gauge

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform TEST VER-1B after each repair.

CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.

Using scan tool, stop actuation test. Turn ignition off. Disconnect MIC connector. Remove faulty gauge. Inspect printed circuit board. Replace circuit board if necessary. If circuit board is okay, replace faulty gauge.