LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Controls - Tests W/Codes - Body Control Computer) >> Self-Diagnostic Tests >> Test 26B - Shorted Left Door Ajar Circuit

Test 26B - Shorted Left Door Ajar Circuit

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  section at the end of this article. Perform TEST VER-1B after each repair.
  1. Ensure left front door is aligned properly. Align or adjust door as necessary. If door is aligned properly, disconnect left front door ajar switch connector. Check condition of connector, and clean or repair connector as necessary. If connector is okay, go to next step.
  2. Using scan tool, read left front door switch status. If scan tool displays LF DOOR AJAR OPEN, replace left front door ajar switch. If scan tool does not display LF DOOR AJAR OPEN, go to next step.
  3. Turn ignition off. Disconnect Body Control Module (BCM) Blue connector. BCM is located behind left side knee panel. Check condition of connector, and clean or repair connector as necessary. If connector is okay, go to next step.
  4. Using scan tool in ohmmeter mode, check resistance of BCM Blue connector terminal No. 1 (Tan wire). If resistance is more than 5 ohms, replace BCM. If resistance is less than 5 ohms, repair short to ground in Tan wire.
scientia non olet · About LEMON Manuals