LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Generator & Regulator) >> Self-Diagnostic System >> On-Board Diagnostics >> DRB Diagnostic Mode

DRB Diagnostic Mode

WARNING: This page is about a different car, the 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Attach DRB to Data Link Connector (DLC). DLC is located in engine compartment, near PCM.
  2. Start engine (if possible). On A/T models, shift transmission lever through all positions, ending in Park. On all models, turn A/C switch on and then off (if equipped).
  3. Turn engine off. Without starting engine again, turn ignition on. Enter CHARGING MENU. See DRB TEST FUNCTIONS. At CHARGING MENU, press "2" (READ FAULTS) key. Press ENTER key. Read fault messages and perform appropriate test. See SELF-DIAGNOSTIC TESTS.