Fuel Tubes & Fittings: Installation

WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

Apply Parker O-Lube(R) to NEW "O" rings. On 90-degree fittings, back off lock nut as far as possible. Thread fitting into port until back-up washer contacts port face. See Fig 2. Rotate fitting to desired position. DO NOT unscrew fitting more than one full turn. Hold fitting in position, and tighten lock nut.

Fig 1: "O" Ring Type High-Pressure Fitting ID (Ram Van/Wagon)

Courtesy of CHRYSLER CORP.

Fig 2: Tightening 90-Degree "O" Ring Type High-Pressure Fittings (Ram Van/Wagon)

Courtesy of CHRYSLER CORP.