LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Engine Controls - Remove/Install/Overhaul - 5.2L CNG) >> Fuel System >> Fuel Cylinders >> Specific Removal & Installation Procedures

Specific Removal & Installation Procedures

WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. 2 rear cylinders are removed as an assembly by removing carrier assembly bolts located under carpeting (if equipped). Rear seat and spare tire may also need removal. Support cylinders with appropriate jack before bolts are removed.
  2. Left side cylinder is removed as an assembly with carrier bracket assembly. Two carrier bracket bolts are located inside vehicle, behind driver's seat, and 2 bolts are on frame rail. Ensure reference marks are used to return cylinder and control valve to original position. The right cylinder is removed as an assembly from frame rail. Securing bolts are threaded into weld nut plates in interior of frame rail. To access weld nut plates, remove access plugs in floor of vehicle near step well.
scientia non olet · About LEMON Manuals