Fuel Tubes & Fittings: Installation

WARNING: This page is about a different car, the 1995 Plymouth Voyager and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.

Apply Parker O-Lube(R) to NEW "O" rings. On 90-degree fittings, back off lock nut as far as possible. Thread fitting into port until back-up washer contacts port face. See Fig 2 . Rotate fitting to desired position. DO NOT unscrew fitting more than one full turn. Hold fitting in position, and tighten lock nut.

Fig 1: Identifying "O" Ring Type High-Pressure Fittings (Caravan & Voyager)

Courtesy of CHRYSLER CORP.

Fig 2: Tightening 90-Degree "O" Ring Type High-Pressure Fittings (Caravan & Voyager)

Courtesy of CHRYSLER CORP.