LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Engine Controls - Remove/Install/Overhaul - 3.3L Gasoline) >> Ignition System >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect crankshaft position sensor connector from wiring harness connector. Remove sensor retaining bolt. Pull sensor straight up out of transaxle housing. Sensor is located on bellhousing near right cylinder head.

scientia non olet · About LEMON Manuals