LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Engine Controls - Remove/Install/Overhaul - 5.2L Gasoline) >> Ignition System >> Camshaft Position Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. Remove distributor cap. Disconnect camshaft position sensor connector from harness connector. Remove distributor rotor. Lift and remove sensor from distributor. To install, reverse removal procedure.

scientia non olet · About LEMON Manuals