LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Engine Controls - Remove/Install/Overhaul - 5.2L Gasoline) >> Fuel System >> Throttle Body >> Removal & Installation (MFI)

Removal & Installation (MFI)

WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Remove air cleaner components as necessary.
  2. Remove throttle cable, speed control cables and transaxle linkage (if equipped). Disconnect wiring connectors for automatic idle speed motor and throttle position sensor. Disconnect vacuum hoses from throttle body.
  3. Remove throttle body-to-intake manifold attaching nuts. Remove throttle body and gasket. To install, reverse removal procedure. Tighten throttle body attaching nuts.
scientia non olet · About LEMON Manuals