LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Engine Controls - Remove/Install/Overhaul - 5.2L Gasoline) >> Fuel System >> Fuel Injectors >> Removal

Fuel Injectors: Removal

WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove fuel rail. See FUEL INJECTOR RAILS . Disconnect injector wiring connector from injector. Position fuel rail assembly so injectors are accessible.
  2. Rotate and pull injector out of fuel rail (clip will remain on injector). Inspect injector "O" ring and clip for damage. Replace "O" ring if it is damaged. If injector is to be reused, install a protective cap on injector tip to prevent damage. Replace clip if it is damaged. Repeat for remaining injectors.
scientia non olet · About LEMON Manuals