Test NTC-7B - Checking Water-In-Fuel Light
WARNING: This page is about a different car, the 1995 Dodge Pickup and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAMS
section at the end of this article.
Turn ignition off. Using scan tool in ohmmeter mode, check resistance of water-in-fuel connector sensor ground circuit (Black/Light Blue wire). If resistance is more than 10 ohms, repair open Black/Light Blue wire. Perform TEST VER-1. If resistance is 10 ohms or less, replace water-in-fuel sensor. Perform TEST VER-1.