LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Controls - Tests W/Codes - 5.2L CNG) >> Self-Diagnostic Tests >> Test NTC-6A - Checking TP Sensor Calibration

Test NTC-6A - Checking TP Sensor Calibration

WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to ON position, leaving engine off. Using scan tool, read Throttle Position (TP) sensor voltage. Ensure throttle is fully closed and against throttle stop. If voltage is more than 1.5 volts with throttle closed, replace TP sensor. Perform TEST VER-2. If voltage is less than 1.5 volts with throttle closed, observe scan tool voltage display and slowly open throttle to wide open position.
  2. If voltage does not change smoothly, replace TP sensor. Perform TEST VER-2. If voltage changes smoothly, and maximum voltage is less than 3.4 volts at wide open throttle, replace TP sensor. Perform TEST VER-2. If voltage changes smoothly, and maximum voltage is more than 3.4 volts at wide open throttle, TP sensor is okay. Test is complete.
scientia non olet · About LEMON Manuals