Test NS-2B - Inspecting Fuel Relays & Solenoids
WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Disconnect and inspect high pressure fuel shutoff solenoid relay connector. Repair as necessary. Perform TEST VER-1. If connector is okay, turn ignition on. Using scan tool in voltmeter mode, check voltage on high pressure fuel shutoff solenoid relay connector, ignition 12-volt feed circuit (Dark Blue wire on AB and AN bodies; Light Green/Black wire on BR body). If voltage is less than 10 volts, repair open in Dark Blue wire, Dark Blue/White wire or Light Green/Black wire. Perform TEST VER-1.
- If voltage is more than 10 volts, replace high pressure fuel shutoff solenoid relay with a known-good relay. Attempt to start engine. If engine does not start, repair open in Dark Blue/Yellow wire. Perform TEST VER-1. If engine starts, replace fuel high pressure fuel shutoff solenoid relay. Perform TEST VER-1.