LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Engine Controls - Tests W/Codes - 3.9L) >> Verification Tests >> Test VER-1 - No Start Verification Procedure

Test VER-1 - No Start Verification Procedure

WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, 1995 Dodge Dakota, and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect vehicle to ensure all engine components are connected. Reassemble and reconnect components as necessary. Inspect engine oil for fuel contamination. Change oil and filter if necessary. Attempt to start engine.
  2. If engine does not start, check if any Technical Service Bulletins (TSBs) apply to vehicle and return to TEST TC-1A, if necessary. If engine starts and Powertrain Control Module (PCM) was changed, repair is complete. If engine starts and PCM was not changed, connect scan tool to PCM data link connector and erase trouble codes. Repair is complete.
scientia non olet · About LEMON Manuals