LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Engine Controls - Tests W/Codes - 3.9L) >> Self-Diagnostic Tests >> Test TC-23D - IAC Driver #3 Control Circuit

Test TC-23D - IAC Driver #3 Control Circuit

WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, 1995 Dodge Dakota, and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS  section at the end of this article.
  1. Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Inspect connector for damaged, pushed-out or miswired terminals. Repair as necessary. Perform TEST VER-2. If connector is okay, go to next step.
  2. Using an external ohmmeter, check resistance of Idle Air Control (IAC) motor driver No. 3 circuit (Gray/Red wire) between IAC motor connector and PCM terminal No. 39. If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2. If resistance is more than 5 ohms, repair open Gray/Red wire or Yellow/Black wire. Perform TEST VER-2.
scientia non olet · About LEMON Manuals