LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Engine Controls - Tests W/Codes - 3.9L) >> Self-Diagnostic Tests >> Test NTC-6A - Checking Map Sensor Calibration

Test NTC-6A - Checking Map Sensor Calibration

WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, 1995 Dodge Dakota, and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn engine off. Install vacuum "T" in Manifold Absolute Pressure (MAP) sensor vacuum hose. Install vacuum gauge. Start engine, and let it idle. If engine will not idle, maintain a constant RPM above idle.
  2. Using scan tool, read MAP sensor value. If reading is within one in. Hg of vacuum gauge reading, MAP sensor is functioning properly. Test is complete. If reading is not within one in. Hg of vacuum gauge reading, replace MAP sensor. Perform TEST VER-2.
scientia non olet · About LEMON Manuals