Test NTC-16A - No Trouble Code Mechanical Test: Notes

WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, 1995 Dodge Dakota, and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If coming to this test from O2S test, and rich or lean condition is not corrected after checking items listed below, replace Powertrain Control Module (PCM).

At this point in diagnostic test procedure, all engine control systems have been determined to be operating as designed and not causing a driveability problem. Following additional items should be checked as possible causes:

Check distributor position. See CHECKING DISTRIBUTOR POSITION.
Check if any Technical Service Bulletins (TSBs) apply to vehicle.
Check engine vacuum. It must be at least 13 in. Hg in Neutral.
Check valve timing.
Check engine compression.
Check for exhaust system restriction.
Ensure PCV system is functioning properly.
Check camshaft and crankshaft sprockets.
Check torque converter stall speed.
Check power booster for internal vacuum leak.
Check for fuel contamination.
Ensure injector control circuit is connected to correct fuel injector and injector is not plugged or restricted.