Test NS-8A - Correcting Start & Stall Condition: Notes
WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, 1995 Dodge Dakota, and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
At this point in diagnostic test procedure, all engine control systems have been determined to be operating as designed and not causing a start and stall problem. Check following items as possible causes:
- Check if any Technical Service Bulletins (TSBs) apply to vehicle.
- Check distributor position. See CHECKING DISTRIBUTOR POSITION.
- Check valve timing.
- Check engine compression.
- Check for exhaust system restriction.
- Ensure PCV system is functioning properly.
- Check camshaft and crankshaft sprockets.
- Check for fuel contamination.
- Check secondary ignition system.