Test NS-6C - Correcting No Response Condition

WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, 1995 Dodge Dakota, and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS section at the end of this article.

Disconnect fuel pump harness connector. Using scan tool in ohmmeter mode, check resistance of fuel pump relay connector, fuel pump relay output circuit (Dark Green/Black wire). If resistance is less than 5 ohms, repair short to ground in Dark Green/Black wire. Replace fuse. Perform TEST VER-2. If resistance is more than 5 ohms, replace fuel pump. Replace fuse. Perform TEST VER-1.