LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Engine Controls - Tests W/Codes - 3.8L) >> Verification Tests >> Test VER-1 - No Start Verification Procedure

Test VER-1 - No Start Verification Procedure

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure all engine components are connected. Reassemble and reconnect components as necessary. Inspect engine oil for fuel contamination. Change oil and filter if necessary. Attempt to start engine.
  2. If engine does not start, check if any Technical Service Bulletins (TSBs) apply to vehicle and return to TEST TC-1A, if necessary.
  3. If engine starts and Powertrain Control Module (PCM) was replaced, repair is complete.
  4. If engine starts and PCM was not replaced, connect scan tool to data link connector and erase DTCs. Repair is complete.
scientia non olet · About LEMON Manuals