Test NS-9C - Repairing No Crank Condition
WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAMS
section.
- If engine cranks, replace starter relay. Perform TEST VER-1. If engine does not crank, disconnect jumper wire. Disconnect starter relay Brown wire from starter solenoid.
- Using an external ohmmeter, check resistance of Brown wire between starter relay connector and starter solenoid. If resistance is more than 5 ohms, repair open Brown wire. Perform TEST VER-1. If resistance is less than 5 ohms, reinstall starter relay.
- Check battery cables for high resistance. If either battery circuit has a voltage drop of more than .2 volt, repair battery circuit for high resistance. Perform TEST VER-1. If voltage drop for either battery circuit is less than .2 volt, go to next step.
- If starter solenoid clicked when jumper wire was connected in last step of TEST NS-9A (auto. trans.) or TEST NS-9B (man. trans.), repair starter for a mechanical failure. Perform TEST VER-1. If starter solenoid did not click when jumper wire was connected, replace starter solenoid. Perform TEST VER-1.