Test NS-9A - Repairing No Crank Condition
WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAMS
section.
- If vehicle is equipped with a manual transmission, go to TEST NS-9B. If vehicle is equipped with an automatic transmission, ensure transmission is in Park.
- Using scan tool, read park/neutral position switch sense. If park/neutral position switch senses park, go to next step. If park/neutral position switch does not sense park, repair open park/neutral position switch ground.
- Disconnect starter relay. Using scan tool in voltmeter mode, check voltage on starter relay connector Red/Yellow wire. If voltage is less than 10 volts, repair open Red/Yellow wire. Perform TEST VER-1.
- If voltage is more than 10 volts, using an external voltmeter, check voltage on starter relay connector Yellow wire. Hold ignition switch in RUN position while observing voltmeter. If voltage is less than 10 volts, repair open Yellow wire. Perform TEST VER-1.WARNING: Engine may crank in following step. Keep away from moving engine parts.
- If voltage is more than 10 volts, ensure transmission is in Park and parking brake is set. Briefly connect a jumper wire between starter relay connector Red/Yellow wire and starter relay connector Brown wire. Note if engine cranks or starter solenoid clicks. Go to TEST NS-9C.