LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Engine Controls - Tests W/Codes - 2.5L) >> Self-Diagnostic Tests >> Test TC-2B - No Crank Reference Signal At Pcm

Test TC-2B - No Crank Reference Signal At Pcm

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS  .
  1. Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Inspect PCM connector for damaged or pushed-out terminals. Repair as necessary. Perform TEST VER-2. If PCM connector terminals are okay, go to next step.
  2. Using an external ohmmeter, check resistance of Orange wire between CKP sensor connector and PCM connector terminal No. 7. If resistance is more than 5 ohms, repair open Orange wire. Perform TEST VER-2.
  3. If resistance is less than 5 ohms, put scan tool in ohmmeter mode. Using scan tool, check resistance of PCM connector terminal No. 7 (Orange wire). If resistance is more than 5 ohms, replace PCM. Perform TEST VER-2. If resistance is less than 5 ohms, repair short to ground in Orange wire. Perform TEST VER-2.
scientia non olet · About LEMON Manuals