Test TC-11D - No Vehicle Speed Sensor Signal
WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAMS
section.
- Turn ignition off. Disconnect PCM connector. Inspect PCM connector for damaged or pushed-out terminals. Repair as necessary. Perform TEST VER-2. If PCM connector terminals are okay, put scan tool in ohmmeter mode.
- Using scan tool, check resistance on PCM connector terminal No. 47 (White/Orange wire). If resistance is less than 5 ohms, repair short to ground in White/Orange wire. Perform TEST VER-2.
- If resistance is more than 5 ohms, using an external ohmmeter, check resistance of White/Orange wire between VSS connector and PCM connector terminal No. 47. If resistance is more than 5 ohms, repair open White/Orange wire. Perform TEST VER-2. If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2.