Test NS-9B - Repairing No Crank Condition
WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAMS
section.
- Disconnect starter relay. Put scan tool in ohmmeter mode. Using scan tool, check resistance on starter relay connector Black/Orange wire. If resistance is more than 5 ohms, repair open in appropriate wire. Perform TEST VER-1.
- If resistance is less than 5 ohms, put scan tool in voltmeter mode. Using scan tool, check voltage on starter relay connector Red/Yellow wire. If voltage is less than 10 volts, repair open in appropriate wire. Perform TEST VER-1.
- If voltage is more than 10 volts, using an external voltmeter, check voltage on starter relay connector Yellow wire. Hold ignition switch in RUN position while observing voltmeter. If voltage is less than 10 volts, repair open in Yellow wire. Perform TEST VER-1.WARNING: Engine may crank in following step. Keep away from moving engine parts.
- If voltage is more than 10 volts, ensure transmission is in Neutral and parking brake is set. Briefly connect jumper wire between starter relay connector Brown wire and Red/Yellow wire. Go to TEST NS-9C.