LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Controls - Tests W/Codes - 2.5L) >> Self-Diagnostic Tests >> Test TC-11D - No Vehicle Speed Sensor Signal

Test TC-11D - No Vehicle Speed Sensor Signal

WARNING: This page is about a different car, the 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagrams, see WIRING DIAGRAM  section.
  1. Turn ignition off. Disconnect PCM connector. Inspect PCM connector for damaged or pushed-out terminals. Repair as necessary. Perform TEST VER-2. If PCM connector terminals are okay, put scan tool in ohmmeter mode.
  2. Using scan tool, check resistance on PCM connector terminal No. 47 (White/Orange wire). If resistance is less than 5 ohms, repair short to ground in White/Orange wire. Perform TEST VER-2.
  3. If resistance is more than 5 ohms, using an external ohmmeter, check resistance of White/Orange wire between VSS connector and PCM connector terminal No. 47. If resistance is more than 5 ohms, repair open White/Orange wire. Perform TEST VER-2. If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2.
scientia non olet · About LEMON Manuals