LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Controls - Tests W/Codes - 2.5L) >> Self-Diagnostic Tests >> Test TC-11B - No Vehicle Speed Sensor Signal

Test TC-11B - No Vehicle Speed Sensor Signal

WARNING: This page is about a different car, the 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagrams, see WIRING DIAGRAM  section.
  1. Turn ignition off. Disconnect VSS connector. Inspect vehicle speed sensor connector for damaged or pushed-out terminals. Repair as necessary. Perform TEST VER-2. If VSS connector terminals are okay, go to next step.
  2. Turn ignition on. Put scan tool in voltmeter mode. Using scan tool, check voltage on VSS connector Orange wire. If voltage is less than 7 volts, repair open Orange wire. Perform TEST VER-2.
  3. If voltage is more than 7 volts, using scan tool, check voltage at VSS connector White/Orange wire. If voltage is less than 4 volts, go to TEST TC-11D. If voltage is more than 4 volts, connect a jumper wire to VSS connector White/Orange wire.
  4. Using scan tool, read VSS signal. While observing scan tool display, touch other end of jumper wire to VSS connector Black/Light Blue wire. If scan tool displays more than zero MPH, go to next step. If scan tool does not display more than zero MPH, go to TEST TC-11E.
  5. Remove VSS from vehicle. Inspect speedometer pinion gear. If speedometer pinion gear is damaged, replace pinion gear. Perform TEST VER-2. If speedometer pinion gear is not damaged, replace VSS. Perform TEST VER-2.
scientia non olet · About LEMON Manuals