LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Removal & Installation - M/T) >> Transmission Removal & Installation >> All Models Except "S" & "T" Series >> Installation

All Models Except "S" & "T" Series: Installation

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 1990 Pontiac Trans Sport, 1990 Oldsmobile Silhouette, 1990 GMC Vandura Special, 1990 GMC Vandura, and 1990 GMC Value Van. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that plugs located in rear of bellhousing below transmission mounting bolt holes are tight and not damaged. Note location before removal. Install new plugs if plugs are damaged.
  2. Apply a light coat of high-temperature grease to the main drive gear splines. Place the transmission in high gear. Install Guide Pins (J-1126) (if used). Reverse removal procedures to complete installation. Tighten mounting bolts to specification. Refer to TORQUE SPECIFICATIONS (ALL EXCEPT "S/T" SERIES) .
scientia non olet · About LEMON Manuals