Deployed Air Bag
WARNING: This page is about a different car, the 1995 Dodge Pickup and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Vehicle interior will contain sodium hydroxide powder, a by-product of air bag deployment. Since this powder can irritate skin, eyes, nose, or throat, be sure to wear safety glasses, rubber gloves, and long-sleeved shirt during clean-up.
- Take measures to avoid breathing powder produced during air bag deployment. Place a piece of tape over air bag vent hole to prevent additional powder spillage. Remove driver-side air bag module and passenger-side air bag module (if equipped). Use vacuum cleaner to remove residual powder from A/C-heater outlets and vehicle interior.
- Turn blower motor to low for a few minutes and exit vehicle. Turn blower off. Vacuum any other powder expelled from plenum. Vacuum interior a second time to recover all powder. Avoid kneeling or sitting on uncleaned surfaces. Dispose of deployed air bags as any other part.