Removal (AX15)
WARNING: This page is about a different car, the 1995 Dodge Pickup, 1995 Dodge Dakota, and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Shift transmission lever to Neutral. Raise and support vehicle. Disconnect necessary exhaust components. Support transmission with jack and remove rear crossmember and lower transmission slightly. Press shift lever retainer downward and turn it counterclockwise to release shifter.
- Drain transmission fluid. Mark drive shaft and rear axle yokes for reassembly reference. Remove drive shaft. Disconnect crankshaft position sensor connector. Loosen sensor coupling and remove sensor from speedometer adapter. Remove speedometer adapter and pinion gear. Disconnect park/neutral position switch connector.
- Place jack under engine oil pan. Protect pan with wood. Raise engine slightly. Remove clutch slave cylinder and secure aside. Remove starter motor. Disconnect insulator from extension housing.
- Remove clutch housing-to-engine bolts. Support transmission with transmission jack. Remove center crossmember. Slide transmission rearward and lower from vehicle.