Code 24, VSS (Except 3.1L, 3.8L & Models W/4L80-E Trans.): Notes
WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 1992 GMC Yukon, 1992 GMC Vandura Special, 1992 GMC Vandura, 1992 GMC Value Van, and 1992 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
ECM applies and monitors 12 volts on circuit No. 437. Circuit No. 437 is connected to Digital Ratio Adapter Controller (DRAC) which alternately grounds this circuit when it is receiving voltage pulses from Vehicle Speed Sensor (VSS). Scan tester reading should closely match speedometer reading.
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- Code 24 will set if voltage on circuit No. 437 is constant, engine speed is greater than 1200 RPM, vehicle speed is less than 2 MPH, vehicle is not in Park or Neutral and all conditions have been met for at least 5 seconds. These conditions are met during a road load deceleration.
- This determines if DRAC is receiving AC signal from VSS.
- This test monitors DRAC voltage on circuit No. 437. With wheels turning, pulsing voltage should be present. Voltage variation will be greater at a low speed to an average of 4-6 volts at about 20 MPH.