LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wiper System/Washer System - G Series Vans) >> Testing >> Wiper Motor Inoperative Testing

Wiper Motor Inoperative Testing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1991 GMC Vandura Special, 1991 GMC Vandura, 1991 GMC Rally Camper Special, 1991 GMC Rally, and 1991 GMC Magnavan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition to RUN position and wiper switch to HI position. Connect test light between White wire at wiper motor connector C248 and ground. See Figure . If test light illuminates, go to step 2). If test light does not illuminate, check wiper fuse or repair open in White wire between wiper motor connector C277 and fuse block.
  2. Connect a fused jumper wire from Black wire at wiper switch connector C259 to ground. If wiper motor runs, locate and repair open between wiper switch connector C259 and ground. If wiper motor fails to run, replace wiper motor.