Drive Axle Assembly Specifications
PINION DEPTH CODES
| Original Code | Service Code | Correction In. (mm) |
|---|---|---|
| +2 | +2 | 0 (0) |
| +2 | +1 | -.001 (-.025) |
| +2 | 0 | -.002 (-.050) |
| +2 | -1 | -.003 (-.074) |
| +2 | -2 | -.004 (-.098) |
| +1 | +2 | +.001 (+.025) |
| +1 | +1 | 0 (0) |
| +1 | 0 | -.001 (-.025) |
| +1 | -1 | -.002 (-.050) |
| +1 | -2 | -.003 (-.074) |
| 0 | +2 | +.002 (+.050) |
| 0 | +1 | +.001 (+.025) |
| 0 | 0 | 0 (0) |
| 0 | -1 | -.001 (-.025) |
| 0 | -2 | -.002 (-.050) |
| -1 | +2 | +.003 (+.074) |
| -1 | +1 | +.002 (+.050) |
| -1 | 0 | +.001 (+.025) |
| -1 | -1 | 0 (0) |
| -1 | -2 | -.001 (-.025) |
| -2 | +2 | +.004 (+.098) |
| -2 | +1 | +.003 (+.074) |
| -2 | 0 | +.002 (+.050) |
| -2 | -1 | +.001 (+.025) |
| -2 | -2 | 0 (0) |
AXLE ASSEMBLY SPECIFICATIONS
| Application | Measurement In. (mm) | |
|---|---|---|
| Ring Gear Backlash | ||
| Preferred | .005-.008 (.127-.203) | |
| Acceptable | .003-.008 (.076-.203) | |
| INCH Lbs. (N.m) | ||
| Pinion Bearing Preload | ||
| Used Bearings | 5-15 (.6-1.7) | |
| New Bearings | 23-35 (2.6-4.0) | |