LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axle - DANA Full-Floating >> Removal & Installation >> Pinion Flange & Pinion Seal >> Installation

Pinion Flange & Pinion Seal: Installation

  1. Thoroughly clean machined surfaces. Lubricate inside diameter of seal. Pack cavity between pinion stem, pinion flange, and pinion nut washer with a non-hardening sealer.
  2. Using Pinion Seal Installer (J-24384), drive oil seal into place. Using pinion flange holder/remover, install pinion flange and drive pinion nut. Ensure mark made during removal is aligned. Install drive shaft.
scientia non olet · About LEMON Manuals