LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul >> HARRISON Hr-6 & V5 Shaft Seal R & I >> Removal

HARRISON Hr-6 & V5 Shaft Seal R & I: Removal

  1. Discharge system using approved refrigerant recovery/recycling equipment. Using Clutch Plate Spanner (J-25030) for HR-6 or (J-33027-A) for V5, hold clutch plate and remove crankshaft nut. Thread Clutch Plate Remover/Installer (J-33013-B) into clutch plate and remove clutch plate. See Figure and Figure .
  2. Remove shaft seal retaining snap ring. Ensure all surfaces around seal are clean. Install Shaft Seal Protector (J-34614) over compressor shaft. Insert Shaft Seal Remover/Installer (J-23128-A) into shaft seal.
  3. Rotate handle clockwise to seat seal remover/installer in seal. Remove shaft seal. Using "O" Ring Remover (J-9553-01), remove "O" ring.
scientia non olet · About LEMON Manuals