LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul >> HARRISON Hr-6 & V5 Clutch Assembly R & I >> Removal

HARRISON Hr-6 & V5 Clutch Assembly R & I: Removal

  1. Using Clutch Plate Spanner (J-25030 for HR-6 or J-33027-A for V5), hold clutch plate and remove crankshaft nut. Use Clutch Plate Remover/Installer (J-33013-B) to remove clutch plate. See Figure and Figure .
    CAUTION: DO NOT  drive on compressor shaft to remove clutch plate or compressor damage will result.
  2. Remove key from shaft. Remove snap ring. Install Guide (J-33023-A) on front head. Position Puller (J-33020) in slots on pulley assembly. Tighten puller and remove pulley assembly.
  3. Use hammer and Bearing Remover (J-9398-A) to drive bearing from pulley. Disconnect clutch coil electrical wiring.
  4. Scribe reference marks on compressor and clutch coil for reassembly reference. Remove clutch coil using Puller Adapter (J-33023-A) and 2-jaw puller.
scientia non olet · About LEMON Manuals