LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 4.3L V6 - VIN [Z] >> Removal & Installation >> Oil Pan >> Installation

Oil Pan: Installation

  1. Apply sealant GM P/N 1052080 (or equivalent) to the front cover-to-block joint and to the rear crankshaft seal-to-block joint. Apply the sealant for about 25 mm (1 inch) in both directions from each of the four corners. Connect the oil pan gasket to the oil pan. Install the oil pan onto the engine.
  2. Install the oil pan bolts, nuts and reinforcements. Tighten the oil pan bolts to 11 N.m (100 in.lbs) and the oil pan nuts at the corners to 23 N.m (200 in.lbs.). Install the starter. Install the converter housing under the pan.
  3. Install the strut pads. Lower the vehicle. Fill the crankcase the the proper quantity and grade of engine oil. Connect the negative battery cable.
scientia non olet · About LEMON Manuals