LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1990 >> S15 Jimmy RWD, Automatic, 700R4/MD8 >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension - Front (4WD) - Torsion Bar >> Removal & Installation >> Wheel Hub & Bearing Assembly >> Removal

Wheel Hub & Bearing Assembly: Removal

  1. Raise and support vehicle. Remove wheel. Depress brake caliper piston. Detach brake caliper mounting bolts and move aside. Remove disc brake rotor.
  2. Detach dust cover and remove cotter pin, nut retainer, nut and washer. Slide hub/bearing carrier off front axle shaft splines. Inspect steering knuckle grease seal and hub bearing for excessive wear or damage and replace as necessary. If hub wheel stud must be replaced, use Wheel Stud Remover (J-6627-A ).
scientia non olet · About LEMON Manuals