LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1990 >> S15 Jimmy RWD, Automatic, 700R4/MD8 >> Repair and Diagnosis >> Suspension >> Front Suspension >> SUSPENSION - FRONT ( C Series 2WD) >> Removal & Installation >> Steering Knuckle >> Installation

Steering Knuckle: Installation

  1. Install upper and lower ball joint studs in steering knuckle and install nuts. Install shield over steering knuckle seal and onto steering knuckle. Install tie rod end stud into steering knuckle bore.
  2. Install Steering Linkage Installer (J-29193 ) or (J-29194 ). Tighten steering linkage installer to 40 ft. lbs. (54 N.m) to seat tie rod taper. Remove steering linkage installer. Install a new torque nut and tighten to specification.
  3. Install hub and rotor assembly. Adjust wheel bearings. See FRONT WHEEL BEARINGS  under ADJUSTMENTS in this article. To complete installation, reverse removal procedure. Check wheel alignment.
scientia non olet · About LEMON Manuals