LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1990 >> S15 Jimmy RWD, Automatic, 700R4/MD8 >> Repair and Diagnosis >> Suspension >> Front Suspension >> SUSPENSION - FRONT ( C Series 2WD) >> Removal & Installation >> Lower Ball Joint >> Installation

Lower Ball Joint: Installation

  1. Position new ball joint in lower control arm bore. Using "C" clamp and Installer (J-9519-16 ), press ball joint into bore until it bottoms on control arm. See Figure . Remove installer tools.
  2. Position grease seal on ball joint so grease purge hole faces inward. Press grease seal on ball joint. Ensure grease seal is fully seated on ball joint. To install remaining components, reverse removal procedure. Lubricate ball joint fitting. Check and adjust wheel alignment.
scientia non olet · About LEMON Manuals