LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1990 >> S15 Jimmy RWD, Automatic, 700R4/MD8 >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axle - 7.5", 7.625", 8.5" & 9.5" >> Removal & Installation >> Axle Shafts & Bearings >> Installation

Axle Shafts & Bearings: Installation

  1. To install, reverse removal procedure. Using Bearing Installer (J-34974 for 7 1/2" and 7 5/8", J-23690 for 8 1/2" and J-29709 for 9 1/2" ring gear), install axle shaft housing bearing until bearing installer bottoms against housing shoulder.
  2. Using Seal Installer (J-33782 for 7 1/2" and 7 5/8", J-21128 for 8 1/2" and J-29713 for 9 1/2" ring gear), install axle shaft housing seal until it is flush with outer edge of axle tube. After installing axle shaft and "C" lock, pull axle shaft outward so "C" lock seats in side gear counterbore. Install pinion shaft and pinion shaft lock bolt.
scientia non olet · About LEMON Manuals